A float-based level sensor with a reed chain is a widely used and comparatively economical solution for continuous level measurement in vessels. Users can define its measuring range flexibly within a given range. This article describes what must be taken into account.
With a reed-chain level sensor, the guide tube includes a defined amount of reed contacts, depending on the measuring range. They are combined to form a measuring chain. The contacts respond to the magnetic field of the float, which moves within the guide tube good liquid level.
Accuracy depends on the length between the contacts
The accuracy of the energy-free level monitoring depends, subsequently, on the distance between the individual contacts: the smaller it is, the more accurate the measurement. Each level sensor in WIKA?s RLT series, for instance, enables measuring ranges with contact distances between 3 and 24 mm. However, a reed chain cannot be stretched across the entire length of the guide tube. For the reason that there are ?dead bands? at both ends of the tube, i.e. sections that the float will not detect due to design constraints (see graphic).
The graph shows how the maximum possible measuring range (M) with an air-handling series level sensor is defined: Guide tube length (L) minus dead band (T) and 100 % mark (X).
Maximum measuring range is not a must
The measuring range of a level sensor therefore lies between the two dead bands specified in the data sheet. Within this range, it might be freely defined. However, it really is by no means necessary to utilise the utmost possible measuring range in every applications. The precise adaptation of the number of contacts to the measuring task also has an economic advantage: The reed chain is one of the most expensive components in a level sensor.
Example ? Dry run monitoring
For dry run monitoring within an oil tank of a compressor, for example, only the lower part of the guide tube is needed for the measurement. In Hurry like this, the upper measuring point of the application (100 % mark) is defined correspondingly low. It marks the length to the sealing face of the procedure connection. The measuring range is thus defined by the following equation:
Measuring range length M = guide tube length L ? dead band T ? 100 % mark X
Consequently, the measuring range for detecting a maximum level is determined starting from the sealing face. In this instance, the guide tube could be adapted to the length of the measuring range.
Note
Further information on the RLT series level sensors are available on the WIKA website. Should you have any questions, your contact will gladly assist you to.
Also read our articles
Level sensors ? the agony of choice
What do dead bands mean with a float switch?
You can also find out more about float-based level measurement using a reed chain in the next video:g